These High-Strength 3" 90 degree hose bends can be used for joining your intake pipe to the throttle body assembly, air metering assembly, intercooler, BOV pipe, or turbo inlet/outlet. They can also be used for custom compressor housings, intercooler or inlet piping for turbo/supercharged car or a custom cold air intake system for your car. Keep in mind that if you purchased a Turbonetics T3/T4 turbo from us you will require one of these for the compressor inlet.

The Hose Dimensions are as follows:
The Inner Diameter is 3" and it is held throughout the 90 Degree Bend
The Outer Diameter is 3.375"
The hose sits 5.5" tall when placed flat on the hose end
High quality 3-ply or 4-ply fabric reinforced silicone can be cut to any length
Heat tolerance: -40° to 392° Fahrenheit
Burst Pressure: 200 PSI
Working Pressure: 50 PSI
Wall Size: 4 mm - 5 mm

Requires two of our 3" T-Bolt Hose Clamps

This item comes in BLUE